Supported Hardware

The board list in the GUI comes from a catalog downloaded at startup, so new boards and images can appear without updating the application.

Boards

Board Flashed via GUI CLI command

BeagleY-AI

SD card

Yes

flash sd

BeaglePlay

SD card

Yes

flash sd

BeagleBone AI-64

SD card

Yes

flash sd

BeagleV-Fire

SD card, eMMC

Yes

flash sd

BeagleBone Black

SD card

Yes

flash sd

PocketBeagle 2

SD card

Yes

flash sd

Generic Linux board

SD card

Yes

flash sd

BeagleConnect Freedom

Serial (USB)

Yes

flash bcf

BeagleConnect Zepto

Serial (UART), I2C on Linux

Yes

flash zepto

The generic Linux board entry lets you flash any SD card image to any board.

Co-processors and other targets

These are mostly useful for development and recovery, and are available in the CLI only:

Target CLI command Notes

BeagleConnect Freedom MSP430 (USB-UART bridge)

flash msp430

Needs the bcf_msp430 build feature.

PocketBeagle 2 MSPM0

flash pb2-mspm0

Run on the PocketBeagle 2 itself. Needs the pb2_mspm0 build feature and root.

USB DFU devices

flash dfu

Included by default.

See Other targets for usage and Features for build features.

Platform notes

  • SD cards work out of the box on every platform and package format.

  • Serial flashing on Linux needs a udev rule for non-root access. See Enable Serial Flashing Support. This applies to Flatpak, AppImage, and the CLI.

  • Snap supports SD cards, and serial flashing after extra setup. I2C (BeagleConnect Zepto) and hidraw (MSP430) flashing are not available in the Snap.

  • I2C flashing of BeagleConnect Zepto is Linux-only.